| 12345678910111213141516171819202122232425262728293031323334353637383940414243 |
- # generated by PrusaSlicer 2.0.0+win64 on 2019-08-09 at 19:59:43
- bed_temperature = 90
- bridge_fan_speed = 50
- compatible_printers =
- compatible_printers_condition = printer_notes=~/.*PRINTER_NOT_VOLCANO.*/
- compatible_prints =
- compatible_prints_condition =
- cooling = 1
- disable_fan_first_layers = 3
- end_filament_gcode = "; Filament-specific end gcode"
- extrusion_multiplier = 1
- fan_always_on = 1
- fan_below_layer_time = 20
- filament_colour = #FF8000
- filament_cooling_final_speed = 3.4
- filament_cooling_initial_speed = 2.2
- filament_cooling_moves = 4
- filament_cost = 27.82
- filament_density = 1.27
- filament_diameter = 1.75
- filament_load_time = 0
- filament_loading_speed = 28
- filament_loading_speed_start = 3
- filament_max_volumetric_speed = 8
- filament_minimal_purge_on_wipe_tower = 15
- filament_notes = "List of manufacturers tested with standard PET print settings:\n\nE3D Edge\nFillamentum CPE GH100\nPlasty Mladec PETG"
- filament_ramming_parameters = "120 100 6.6 6.8 7.2 7.6 7.9 8.2 8.7 9.4 9.9 10.0| 0.05 6.6 0.45 6.8 0.95 7.8 1.45 8.3 1.95 9.7 2.45 10 2.95 7.6 3.45 7.6 3.95 7.6 4.45 7.6 4.95 7.6"
- filament_settings_id = ""
- filament_soluble = 0
- filament_toolchange_delay = 0
- filament_type = PET
- filament_unload_time = 0
- filament_unloading_speed = 90
- filament_unloading_speed_start = 100
- first_layer_bed_temperature = 85
- first_layer_temperature = 230
- inherits = Generic PET
- max_fan_speed = 50
- min_fan_speed = 30
- min_print_speed = 15
- slowdown_below_layer_time = 20
- start_filament_gcode = "M900 K{if printer_notes=~/.*PRINTER_HAS_BOWDEN.*/}200{else}45{endif}; Filament gcode"
- temperature = 240
|
