README.md 1.7 KB
These are the Autodesk Inventor source files.
Parts and their discription:
Base Left No Front Panel:
This is the left half of the main base. It doesn't have a front panel which makes printing much faster than previous versions of the enclosure. The front panel is a separate part.
Base Right No Front Panel:
This is the right half of the main base. It doesn't have a front panel which makes printing much faster than previous versions of the enclosure. The front panel is a separate part.
Base Left Front Panel:
This screws onto the base left part using M3x8 screws.
Base Right Front Panel:
This screws onto the base right part using M3x8 screws.
Base Cover Left:
This screws into the top of the base to cover it using M3x8 screws.
Base Cover Right:
This screws into the top of the base to cover it using M3x8 screws.
RPi 3 Mount:
This is the Raspberry Pi3 mount module. Screws onto the right base with M3x6 screws. The Pi screws to it using M2.5x6 screws.
Regulator Mount:
This is for mounting LM2596 regulators and the MOSFET modules from Amazon. Screws to the base using M3x6 screws.
Base Left Front Panel Card Reader
For use with an Arduino SD Card reader. Untested. https://smile.amazon.com/WINGONEER-reader-module-interface-conversion/dp/B06XHJJWNC/ref=sr_1_4?ie=UTF8&qid=1547362677&sr=8-4&keywords=arduino+sd+card+reader
Base Cover Left 80mm Fan
For use with a 80x10 or 80x25 fan. Fan will mount on top of the cover as there's probably not sufficient room under it. A 80x10 fan might work under the cover, but a 80x25 will definitely not.
Base Cover Left 60mm Fan
This screws into the top of the base to cover it using M3x8 screws.